Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
# 5 8 M
8 * 1 5
4 p c s
# 6 0
M
8 * 1 5
8 p c s
# 7 1 O
D
2 0 * I D 8 .5 * 1 .5
8 p c s
# 7 4
S 5
3 6
6 0
7 1
7 1
6 0
6 0
7 1
6 0 7 1
60
#60 M 8*15 8pcs
71
#71 O D 20*I D 8. 5*1. 5 8pcs
71
#74 S5
5
1
#5 6 M8 1pc
#6 3 M8 * 7 0 1 pc
#7 1 OD20 * I D8 . 5 * 1 . 5 8 pc s
#7 4 S 5
#7 5 S1 3 - 1 7
ASSEMBLY INSTRUCTIONS
STEP 4:
Note: Move the Seat (No.36) to the front of the Slide
Rail (No.3) before assembly to prevent it from gliding
down during assembly.
3
Attach the Slide Rail (No.3) to the Main Frame (No.
1) using 4 Washers (No.71), 4 Screws (No.60) and 4
Flat Screws (No.58). Insert all 8 screws partially into
5 8
the holes first, and then tighten with Allen Wrench
5 8
(No.74).
1
STEP 5:
Attach Sensor Stand (No.5) to Main Frame (No.1)
using 4 Washers (No.71) and 4 Screws (No.60).
Tighten with Allen wrench (No.74).
If you are sitting on the Seat, the arrow sticker on the
Sensor Stand (No.5) must be pointing towards you.
That means the Sensor Stand (No.5) is installed in the
correct direction.
STEP 6:
46
Attach the Meter (No.46) to the Sensor Stand (No.5)
using 1 Screw (No.63), 2 Washers (No.71) and 1
47
71
63
Nylon Lock Nut (No.56). Tighten with Allen Wrench
56
71
5
(No.74) and Spanner (No.75).
Make sure it is not too tight to adjust the angle of Meter
(No.46).
Connect 2 Sensor Wires (No.47) with the wires of the
Meter (No.46).
The assembly is complete!
8
Publicidad
Tabla de contenido
