WEBTEC DP130 Manual Del Usuario página 11

Instruction for use - Programming
Entering the Program Mode (unit is supplied factory calibrated)
Note: If the optional relay output and/or analog output board(s) are installed in the DPM, entering the program mode will
cause both relays to turn off and the analog output to go to its minimum values (0V and 4 mA) regardless of the input
signal value.
To enter the program mode:
1. Flip the rear terminal program enable DIP Switch ON - top DIP switch on right hand side.
2. Press and hold the front panel program key (PGM); the display will say 'run'
3. Continue to press the (PGM) key and press the up arrow key one time; the program LED will turn ON and the display
will show a parameter name.
The following list shows all programming parameter names, the default value for each, and the selection range for each.
A programmed unit may be returned to the default state by pressing both the program ( PGM ) and right arrow ( ) keys at
the same time for one second. The display will show dFL while the keys are pressed and blink OFF momentarily when
the default is done.
9