Basic Operation - WEBTEC DP130 Manual Del Usuario

Introduction
This manual describes the use and installation of the Webtec DP130 series digital panel meter. There are four products
in the DP130 range, see model table for details, this manual covers all four units.
Before first operating the equipment read the whole of these instructions. Safety may be impaired if they are not
followed.
Webtec have been designing and manufacturing flow meters and hydraulics components for over 40 years. We operate
within a Quality Management System that complies with the requirements of BS EN ISO 9001 which is externally
audited and certificated each year.
Beyond compliance to the standard, Webtec is committed to continually improving in everything we do; with particular
emphasis on understanding what matters to our customers and suppliers, and designing our systems and work to
meet their needs. We are always keen to hear from customer who may have special requirements not covered by our
standard ranges.

Basic operation

The DP130 converts a linear, 4-20 mA current input or 0-10 V signal into a digital readout for the observer. The display
can be scaled to read out in units other than volts or amps. If purchased as a complete system this may already be
complete. The display can be scaled or re-scaled to read out in any units. The units can be AC or DC powered and may
have relay and analogue outputs.
1