Publicidad
Idiomas disponibles
Idiomas disponibles
Preliminary check of the case
Make a preliminary submersion test on the waterproof case
before positioning the digital camera
Before installing the digital camera in the case, make sure that there is no
water leakage.
1
Check the outside of the waterproof case to make sure that there
are no cracks or faults with it.
2
Open the waterproof case using the special pick (included).
3
Check the inside of the waterproof case for the following:
open/close knob
➀
➁
O-ring
• Cracks (especially around the O-
• Correct seating of the O-ring (For
• That the O-ring has no scratches
• Sand or foreign particles stuck to
EN-8
special pick (included)
Release the lock of the open/close
knob.
Turn the open/close knob in the
direction of the "OPEN" arrow to
open the waterproof case.
When opening the waterproof case,
take care not to catch your fingers or
palm in the waterproof case.
You can also use the adjuster of the
strap if you do not have the special
pick (p.15).
ring)
correct installation of the O-ring,
see p.23.)
or cracks, or that it is oddly shaped,
twisted, detached, etc.
the O-ring
Publicidad
