Publicidad
Idiomas disponibles
Idiomas disponibles
Positioning the Digital Camera in the Waterproof Case
3
Insert the silica gel pack into the space underneath the bottom of
the camera.
Silica gel pack
4
Confirm the following before closing the waterproof case.
Silica gel pack
5
When all is well, close the waterproof case (p.10).
→
Check that the camera's "POWER" button and Mode dial can be correctly
operated using the controls on the housing.
When closing the waterproof case, take care not to catch your fingers or
palm in the waterproof case.
To prevent water leaks
Any foreign particles attached to
the O-ring may cause a water leak.
Remove the foreign particles (see
p.21). If you cannot remove them,
replace the O-ring with a new one.
• No part of the silica gel pack is
• There is no dust, hair, or other
O-ring
• The camera is correctly seated and
EN-12
Make sure to insert the silica gel
pack correctly. If it is incompletely
inserted, it will prevent the O-ring
from acting as a seal, and water will
leak in.
protruding.
foreign particle on the O-ring, in
the O-ring groove, or on the edge
face of the waterproof case that
engages with the O-ring.
aligned in the waterproof case.
Hair
Lint
Sand
Publicidad
