Switching The Device On - Olympia ECS 615.2 CCD Manual De Instrucciones

4 Starting Up
1. Remove the device carefully from the packaging.
The underside of the cutting mechanism attachment has sharp edges. Risk
Attention:
of injury!
2. Place the device on a level surface.
3. Position the device near a power socket. However, do not position it near a source of
heat or water.
4. Insert the waste bin.
The shredder only operates when the original waste bin is inserted cor-
Note:
rectly.
5. Set the On/Off switch to its OFF position.
6. Connect the power plug to a power socket.
Pay attention that the power cable is laid so that people or pets do not walk
Note:
over it or that other objects can be set down on it. Pay attention to the in-
formation regarding power supply on the rear side of the device for the
necessary precautions.
Safety information:
5 Operation
The recommended capacities stipulated in Chapter "Technical Data" must
Note:
not be exceeded, otherwise material will jam! Do not forget that the thick-
ness of the paper increases when folded, as a result of which the recom-
mended sheet capacity can be exceeded. Also reduce the quantity of pa-
per when shredding coarse paper.
5.1

Switching the device on

Set the On/Off switch to its ON position.
●
The green "power on" lamp lights up.
The device is ready to operate.
For reasons of safety, the power socket to which the
shredder power plug is connected must be near to the
device and freely accessible so that the power supply can be
disconnected quickly in an emergency!
19