1.800.561.8187
EN-4
6.
Connect the cable to the two connectors (3 Pin and 6 Pin), and plug these two
connectors to the terminal block (J1 & J2).
J2
J1
7.
Secure the cable gland and put the terminal cover back on.
IMPORTANT: When connecting any AC line supplied device to the Discrete I/O PCB,
ensure that each external device utilizes a properly grounded AC connection
CAUTION: Do not operate the discrete I/O without the terminal cover in place
IMPORTANT: Review the I/O menu before using the discrete I/O board to control
external devices.
www.
Discrete I/O Interface
J3
.com
.
information@itm.com