Publicidad
Idiomas disponibles
Idiomas disponibles
How
to attach
tool
cover
The tool cover is designed with a "break-
away" feature which allows it to snap free if
it is pushed open too far.
To reattach, align hinges of cover with slots
on sides of tool storage area.
Push cover down to secure in place.
Cleaning
tools
Tools allow for cleaning surfaces above
the floor and for reaching hard to clean
areas.
Handle must be in the upright posi-
tion for tool use.
CAUTION:
Agitator
continues
to rotate
while
cleaner
handle
is in upright
position.
Avoid
tipping
cleaner
or
setting
it on furniture,
fringed
area
rugs
or carpeted
stairs
during
tool
use,
F
E
Attach
wand
and tools
Attach tool or wand to the hose (E).
Attach second wand or tool to wand (F)
by pushing it firmly onto the wand.
Twist wand or tool slightly to tighten or
loosen the connection.
How
to clean
tools
To clean the hose and the powered
hand tool, wipe off dirt with a cloth
dampened
in a mild detergent.
Rinse
with a damp cloth. Do not submerge
powered hand tool in water.
Cleaning tools may be washed in warm
water with a detergent.
Rinse and air dry
before using.
J
|
J
K
(
))
L
(
))
Select
proper
tool
G. Dusting brush may be used for
carved furniture, table tops, books,
lamps, lighting fixtures, venetian blinds,
baseboards,
shutters, and registers.
H. Furniture
nozzle may be used for
upholstered furniture, draperies,
mat-
tresses, clothing, automobile
interiors,
and carpeted stairs.
I. Powered hand tool* may be used for
upholstered furniture, carpeted stairs
and hard-to-reach
places.
J. Crevice tool* may be used in tight
spaces, corners and along edges in
such places as dresser drawers, uphol-
stered furniture, stairs and baseboards.
K. Crevice wand* can be used in tight
spaces, corners and along edges in
such places as dresser drawers, uphol-
stered furniture, stairs, and baseboards.
It can also be used for extra reach with
the dusting brush and/or extension
wand.
L. Wands are used to give extra length
to your hose. Use them with any of the
above tools.
*some models
Extra
reach
hose*
Push ON/OFF switch to OFF position.
Remove regular hose from cleaner. Align
end of extra reach hose with projections
(M) over slots (N) in dirt duct.
Slide hose into (N) and twist hose to lock
it into place. (To detach hose, reverse
procedure.) Attach wands or tools to the
other end of hose.
*Available at additional cost if not includ-
ed with your cleaner.
7
Publicidad
