Angelo Po 0S0VTR Manual De Uso página 137

HANDLING AND INSTALLATION
NOTE:
The appliance is supplied at an operating
voltage of 400V/2N (indicated on the stick-
er applied to the nameplate); the conversion
to 230V3~ or 230V/1N (for 0S0VTR version
only) can be carried out as described below.
HAZARD: Before doing any work, turn
off the general power supply.
C
B
D
Remove the test voltage sticker from the
5)
nameplate and apply the new one to high-
light the voltage being used.
NOTE: After completing the opera-
tion, check for any faults.
3395250_inst_GB
CONVERSION OF POWER SUPPLY
C
230V 3
Pull off the knobs (B).
1)
Undo the screws (C) and remove the control
2)
panel (D).
Change the connections of the terminal
3)
board as shown in the fi gure and in the wiring
diagram at the end of the manual.
After completing the operation, fi t everything
4)
back in place.
0S0VTR
230V 1N
ENGLISH
1S0VTR
230V 3
11