Publicidad
Idiomas disponibles
Idiomas disponibles
Transportation & Storage
Store the Pull Connect, turned OFF and in the provided
carrying bag. Store in a cool, dry place. If left in the car
on a hot day allow a few minutes for the unit to cool
before turning ON or charging. The unit will not work if it
is overheated. Do not store outdoors where the carrying
bag can get wet, it is not waterproof.
Charging
• Do not expose a battery pack or tool to fire
or excessive temperature. Exposure to fire or
temperature above 265°F (130°C) may cause
explosion.
• Do not charge tool if wet or in a wet
environment. Moisture near electronics increases
the risk of a short circuit causing a fire.
• Follow all charging instructions and do not
charge the battery pack or tool outside
the temperature range specified in the
specifications. Charging improperly or at
temperatures outside the specified range may
damage the battery and increase the risk of fire.
• Recharge only with the charger specified by the
manufacturer. A charger that is suitable for one
type of battery pack may create a risk of fire when
used with another battery pack.
If the lowest segment of the battery icon is flashing
rapidly, the battery is low and needs to be charged. When
charging, each segment will go from flashing to solid as
the battery charge level increases. When the battery
is fully charged, all three segments will be solid green.
(Fig.18)
To charge, plug the power cord into the port marked with
the lightning bolt (Fig.19) then plug into a wall socket
using a USB wall adapter. The Pull Connect can be
operated while charging but the time to full charge will
be extended.
If the product fails to charge or turns off unexpectedly,
refer to Troubleshooting section. Do not attempt to open
the Pull Connect to change the battery.
Figure 18
52094539 REV 03
max
122°F/50°C
Lorem ipsum
Figure 19
© 2024 Greenlee Tools, Inc.
Cleaning
• Do not attempt to open the tool. It contains no
user-serviceable parts.
Make sure that all lights are clean and visible at a distance.
Do not use alcohol or other solvents to clean the device.
Wipe the device with a water damp cloth. Allow to dry
completely before turing ON and using.
Service
• Tool service must be performed only by qualified
repair personnel. Service or maintenance
performed by unqualified personnel could result in
a risk of injury.
• When servicing a tool, use only identical
replacement parts. Use of unauthorized parts
or failure to follow maintenance instructions may
create a risk of electric shock or injury.
• Do not perform any service or maintenance
other than as described in this manual. Personal
injury or damage to the tool may result.
Disposal
This tool contains a lithium-ion battery
and can be recycled. Do not dispose of
this item with regular waste.
Li-ion
Parts of these tools contain valuable materials and can be
recycled. There are companies that specialize in recycling
that may be found locally. Dispose of the components in
compliance with all applicable regulations. Contact your
local waste management authority for more information.
Pull Connect
15
Publicidad
