Levenhuk Ermenrich Ping SM150 Guia Del Usuario página 12

Specifications
Application
AC voltage
DC voltage
Output signal frequency
Overvoltage category
Wire detection distance
Transmitter fuse
Wire tracing
Non-contact voltage detection (NCV)
Pipe blockage detection
Backlight
Sensitivity adjustment
Operating temperature range
Power source
The manufacturer reserves the right to make changes to the product range and specifications without prior notice.
Care and maintenance
Use the device only as specified in the user manual. Do not connect the device to a high-voltage wire as it is life-threatening and it will damage
the device. In order to avoid lightning strikes, do not use the device during thunderstorms. The rated voltage of the tested circuit must not be
greater than 400V. Do not leave the device in the heat or in the direct sunlight. Do not exclusively rely on the detector to locate items behind
scanned surfaces. Do not try to disassemble the device on your own for any reason. For repairs and cleaning of any kind, please contact your
local specialized service center. Protect the device from sudden impact, excessive mechanical force, and strong electromagnetic fields. Store
the device in a dry cool place. Only use accessories and spare parts for this device that comply with the technical specifications. Never attempt
to operate a damaged device or a device with damaged electrical parts! If a part of the device or battery is swallowed, seek medical attention
immediately.
Battery safety instructions
Always purchase the correct size and grade of battery most suitable for the intended use. Always replace the whole set of batteries at one
time; taking care not to mix old and new ones, or batteries of different types. Clean the battery contacts and also those of the device prior
to battery installation. Make sure the batteries are installed correctly with regard to polarity (+ and –). Remove batteries from equipment
that is not to be used for an extended period of time. Remove used batteries promptly. Never short-circuit batteries as this may lead to high
temperatures, leakage, or explosion. Never heat batteries in order to revive them. Do not disassemble batteries. Remember to switch off
devices after use. Keep batteries out of the reach of children, to avoid risk of ingestion, suffocation, or poisoning. Utilize used batteries as
prescribed by your country's laws.
Levenhuk International Warranty
Levenhuk products, except for their accessories, carry a 5-year warranty against defects in materials and workmanship. All Levenhuk accessories
are warranted to be free of defects in materials and workmanship for six months from the purchase date. The warranty entitles you to the free
repair or replacement of the Levenhuk product in any country where a Levenhuk office is located if all the warranty conditions are met.
For further details, please visit: levenhuk.com/warranty
If warranty problems arise, or if you need assistance in using your product, contact the local Levenhuk branch.
сable, live wiring, metal pipes
12–400V (50–60Hz) ±2.5%
12–400V ±2.5%
125kHz
Cat.III, 300V
single pole method: 0–1m /
double pole method: 0–0.5m
single loop line: 0–2.5m / circuit voltage detection: 0–0.4m
transmitter: 80–300mA
receiver: 100–300mA
0.5A, 500V
+
+
+
+
+
0...+40°C (operating), –20...+60°C (storage) /
+32...+104°F (operating), –4...+140°F (storage)
transmitter: rechargeable lithium battery, 3.7V, 1400mA·h
receiver: rechargeable lithium battery, 3.7V, 1400mA·h
12