Publicidad
Idiomas disponibles
Idiomas disponibles
To increase the detection distance up to 2m, use a separate wire or a cable reel as a return wire.
!
For underground wires detection, it is important that the distance between the feeder wire and the return wire is greater than the
depth the wire is buried at (not less than 2m).
De-energized wire tracing. Double pole application. Grounding connection
1.
Clamp the red alligator clip to the terminal of the testing circuit or to the loose end of the testing wire.
2.
Clamp the black alligator clip to the grounding terminal of the testing wire or to the effective grounding wire.
3.
Press the Start/Pause button (10) on the transmitter to turn on the output signal. The receiver will automatically start tracing the high-
frequency signal to detect the wire location.
4.
Place the receiver near the wire and move the receiver sensor along the wire to trace it. To locate the wire more accurately, lower the
sensitivity. The closer the device is to the object, the stronger the signal will be.
!
The effective ground wire shall be no less than 2m away from the target wire. Otherwise, crosstalk may occur and the detection
distance will be too short.
Tracing of a de-energized cable with multiple parallel wires
For the tracing of a cable with multiple parallel wires, it is recommended to apply the single pole method.
1.
Clamp the red alligator clip to the loose end of the testing wire.
2.
Clamp the black alligator clip and the parallel wires to the effective grounding wire or to the grounding rod.
Press the Start/Pause button (10) on the transmitter to turn on the output signal. The receiver will automatically start tracing the high-
3.
frequency signal to detect the wire location.
4.
Place the receiver near the cable and move the receiver sensor along the wire to trace it.
the sensitivity
. The closer the device is to the object, the stronger the signal will be.
!
The negative interface of the transmitter must be connected to the effective grounding. Otherwise, the detection distance will be too short.
Negative
loop
The distance between the target wire and the negative loop
is more than 2meters
Testing wire
Effective grounding
7
Target
wire
To
the wire more accurately, lower
locate
Publicidad
