Publicidad
Idiomas disponibles
Idiomas disponibles
PLACEMENT OF THE MOUNTING PLATE
1
.
A
REMOVING THE MICROWAVE
OVEN FROM THE CARTON/
REMOVING THE MOUNTING
PLATE
Remove the top cover board, installation
1
instructions, use and care, exhaust adapter,
turntable ring, shelf, filters, glass tray and the
bag.
small hardware
Styrofoam protecting the front of the oven.
Shelf (For
some models)
Filters and Turntable Ring below glass tray
Fold back all 4 carton flaps fully against carton
2
sides. Then carefully roll the oven and carton over
onto the top side. The oven should be resting in
the Styrofoam.
Styrofoam
Pull the carton up and off the oven.
3
Installation Instructions
Do not remove the
Small Hardware Bag
Exhaust Adapter
Carton
4 Cut the middle of the outer protective plastic bag to
remove the
m
ounting late
Screws
Remove the screws from each end of the mounting
5
plate. This plate will be used as the rear wall template
and for mounting. Reinstall the screws into the holes
where they were removed.
.
B
FINDING THE WALL STUDS
Wall
Studs
Center
1
Find the studs, using one of the following
methods:
A. Stud finder – a magnetic device which
locates nails.
B. Use a hammer to tap lightly across the
mounting surface to find a solid sound.
This will indicate a stud location.
After locating the stud(s), find the center by
2
probing the wall with a small nail to find the edges
of the stud. Then place a mark halfway between
the edges. The center of any adjacent studs should
be 16 (40.6 cm) or 24 (61 cm) from this mark.
3
Draw a line down the center of the studs.
THE MICROWAVE MUST BE CONNECTED TO
AT LEAST ONE WALL STUD.
EN-6
p
Screws
Mounting Plate
Publicidad
