Descargar Imprimir esta página

MSW Motor Technics MSW-AIRN90FN Manual De Instrucciones página 27

Clavadora para marcos

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 94
with reduced mental, sensory and intellectual abilities. The work area should
provide immediate access to the compressed air shut-off valve. Make sure that the
pressure of the air supply to the unit does not exceed the recommended range.
ASSEMBLY OF THE UNIT
The device is driven by compressed air - the supply connection of the device should
be equipped with an air preparation kit, i.e. a dryer, an oiler (lubricator) and a
pressure regulator:
a) Compressed air source
b) Air regulator
c)
Air dryer
d) Grease gun
e) Compressed air hose
f)
Pneumatic quick coupler
Before connecting the device to the compressed air system, it should be
depressurized. If you do not have a lubricator in your compressed air system, you
should drip 2 drops of pneumatic equipment oil through the air inlet before each
use of the device.
3.3.
Working with the device
3.3.1
OPERATING PRINCIPLE
ATTENTION: before any work on the device, such as adjusting, filling
the magazine, etc. and never point the outlet towards yourself,
After placing the nozzle on the element and pressing the
trigger, the device will fire and apply a nail to the material.
Another application of the nozzle to the material and
pressing the trigger once again will apply the nail, and so on.
Avoid working with the device on edges, hammering nails
onto other nails, or on materials that are too hard.
Never carry the device while holding the trigger.
Always hold the device firmly by the handle - risk of kickback,
which is normal with this type of device.
EN

Publicidad

loading