Publicidad
Idiomas disponibles
Idiomas disponibles
Air leakage from
between the
housing and the
front cover
Air leakage from
between the
housing and the
cylinder cover
Nails are hammered
in too deep
The device is
running slowly or
losing power
The device skips
nails during
application
Nails get stuck in the
machine or its
magazine.
Damaged piston seal or
tappet.
Loose housing screws
The seal is defective.
The pusher is worn
Working pressure is too
high.
No lubrication.
Weak air supply.
Defective spring in the
cylinder cover.
Blocked exhaust hole in the
cylinder head
Worn pusher or spring.
Dirt in the front cover.
Inadequate airflow to the
device.
Worn or dry piston seal.
Defective seal on the trigger
valve.
The cylinder cover is letting
through.
Worn guide bar.
The nails in the machine are
unsupported or damaged.
The bolts of the magazine or
the buckles of the front
cover are loose
The blade in the piston
assembly is damaged.
Worn blade in the piston
assembly.
EN
Check the component in
question and replace it if
necessary.
Tighten the screws.
Check the gasket and
replace it if necessary.
Replace the pusher.
Reduce the pressure on the
regulator.
Add oil to the inside of the
device as described in the
instructions.
Check the air supply.
Replace the spring.
Replace damaged internal
components.
Replace the pusher or its
spring.
Clean the outlet channel at
the front.
Check hoses and pneumatic
connections.
Replace or lubricate the
piston seal.
Replace the sealant.
Replace the seal.
Replace the guide.
Replace the nails with the
correct ones.
Tighten the screws.
Replace the piston assembly.
Replace the piston assembly.
Publicidad
