MSW Motor Technics MSW-AIRN90FN Manual De Instrucciones página 30

•
•
3.3.3 Setting the hammering mode
With the lever located on the housing of the device right next to the
trigger, adjust the hammering mode of nails, ie. single or continuous:
Single mode (lever set on the single nail icon) - is used to hammer
nails one at a time. Useful in work where care and accuracy are
required.
EN
After adjusting the nozzle, apply another nail and check
whether the setting has brought the expected result - if not,
adjust until successful.
The amount of air pressure needed to supply the device
depends on the length of the nails and the positioning of the
nozzle.