• After long periods of storage, you need to
charge and discharge the battery several times
to obtain maximum performance.
• Note the positive (+) and negative (-) signs on
the batteries and equipment to ensure correct
use.
• Do not reverse the battery polarity by exchang-
ing the positive and negative terminals.
• Do not connect the battery to an electrical
EN
socket.
• Do not mix batteries of different manufacture,
capacity, size or type in the same device.
• Buy the battery with the capacity recommend-
ed by the manufacturer of the device you in-
tend to use.
• Keep the batteries clean and dry.
• Clean the battery terminals with a clean dry
cloth if they are dirty.
• Keep the original product literature on hand for
future reference.
• Use the battery only in the application for which
it was designed.
• If possible, remove the battery from the system
when not in use.
• Dispose of properly.
Warning! Keep the battery away from
water, dust and any contamination.
Warning! Do not crush or puncture the
battery.
Warning! Never touch the battery con-
tacts or allow objects (conductors) to
touch the contacts.
- 10 -
5.2 Installation
5.3 Instructions for use
TLI PREMIUM
Translation of the original instructions
Warning! 12 V systems only.
Warning! It's possible to connect up
to two batteries TLI PREMIUM in se-
ries or three batteries in parallel ("6.5.1
Multi-battery connection diagram"), as
long as the batteries have the same ca-
pacity.
("2.1 Technical
Caution! Do not reverse the polarity of
the connection cables.
Warning! Using the battery for the first
time
The battery is supplied:
• in storage mode
• NOT fully charged
It is necessary to complete the charge
process ("7.2 Charging") before using
it.
Warning! Do not overload the battery.
Warning! Never short-circuit the bat-
tery.
Caution! Do not operate the battery
beyond the stated maximum specifica-
tions.
Caution! In the case of stoppage due to
undervoltage, recharge immediately.
Warning! When using the battery, al-
ways observe the limits specified in
paragraphs
("2.1 Technical Specifica-
tions") and
("2.2 Environmental condi-
tions").
Specifications").
Rev.001