DITTING 804 Instrucciones De Uso Originales página 31

Before using
Checking grinder and scope of delivery
INFORMATION!
Risk of damage!
The grinder can become damaged if you open the packaging careless-
ly with a sharp knife or other pointed objects.
– Be very careful when opening.
1. Remove the grinder from its packaging.
2. Check if the delivery is complete (see Fig. A and B).
3. Check if the grinder or any of the individual parts are damaged.
If this is the case, do not use the grinder. Contact your supplier
(see chapter "Maintenance and service").
Se ng up the grinder
1. Place the grinder on a level and stable surface that does not vibrate to
prevent it from falling off .
2. Insert the mains plug (13) into a properly installed wall socket.
K 804 LAB (SWEET):
Bring the folding table (9) to the desired height using the adjus ng
screws (10) (see Fig. E). There are three posi ons to choose from.
To do this, fi rst remove the grub screws (14) on both sides at the desired
height and place them in the holes that have now become free a er
se ng the table height to close the holes.
Note that the spread of the grist depends on the distance
between the outlet and the container:
The smaller the distance, the lower the sca ering of the
ground coff ee.
K 804 LAB FILTER:
Fit the fi lter cage retainer (11) at the required height using the adjus ng
screws (12) (see Fig. F).
To do this, fi rst remove the grub screws (14) on both sides at the desired
height and place them in the holes that have now become free a er
se ng the retainer to close the holes.
804 | EN
31