Craftsman 917.20378 Manual Del Operador página 29

TROUBLESHOOTING CHART:
See appropriate section in manual unless directed to Sears service center
PROBLEM CAUSE CORRECTION
Will not start 1 Out of fuel. 1 Fill fuel tank.
2 Engine not "CHOKED" properly, 2 See "TO START ENGINE" in
Operation section,
3 Engine flooded. 3 Wait several minutes before
attempting to start,
4 Bad spark plug. 4 Replace spark plug.
5 Dirty air filter. 5 Clean/replace air filter,
6 Dirty fuel filter, 6 Replace fuel filter.
7 Water in fuel. 7 Empty fuel tank and carburetor,
refill tank with fresh gasoline and
replace fuel filter.
8 Loose or damaged wiring, 8 Check all wiring,
9 Engine valves out of adjustment, 9 Contact a Sears or other qualified
service center
Hard to start 1 Dirty air filter. 1 Clean/replace air filter.
2 Bad spark plug. 2 Replace spark plug.
3 Weak or dead battery, 3 Recharge or replace battery,
4 Dirty fuel filter, 4 Replace fuel filter.
5 Stale or dirty fuel. 5 Empty fuel tank and refill tank wig-
fresh, clean gasoline.
6 Loose or damaged wiring, 6 Check all wiring,
7 Engine valves out of adjustment, 7 Contact a Sears or other qualified
service center
Engine will not 1 Clutch/brake pedal not depressed 1 Depress clutch/brake pedal.
turn over
2 Attachment clutch is engaged. 2 Disengage attachment clutch.
3 Weak or dead battery. 3 Recharge or replace battery.
4 Blown fuse. 4 Replace fuse.
5 Corroded battery terminals. 5 Clean battery terminals.
6 Loose or damaged wiring. 6 Check all wiring.
7 Faulty ignition switch. 7 Check/replace ignition switch.
8 Faulty solenoid or starter. 8 Check/replace solenoid or starter.
9 Faulty operator presence 9 Contact a Sears or other qualified
switch(es), service center.
29