Publicidad
Idiomas disponibles
Idiomas disponibles
Keys
Key(s)
Slope Sheet
Oil Drain
Extension
Your new tractor has been assembled at the factory with exception of those parts left
unassembted for shipping purposes.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes are listed.
(1) 1/2" wrench
Tire pressure gauge
(2) 7/16" wrenches
Utility knife
Pliers
When right or left hand is mentioned in this
manual, it meanswhen you are inthe operating
position (seated behind the steering wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
*
Remove all accessible loose parts and
parts cartons from carton.
*
Cut along dotted lines on all four panels
of carton. Remove end panels and lay
side panels flat.
Check for any additional loose parts or
cartons and remove.
BEFORE REMOVING TRACTOR
FROM SKID
TO ADJUST SEAT
*
Sit in seat.
*
Lift up adjustment tever (A) and slide seat
until a comfortable
position is reached
which allows you to press clutch/brake
pedal all the way down.
*
Release lever to lock seat in position.
TO CHECK BATTERY
1. Lift seat to raised position.
NOTE: If this battery is put into service after
month and year indicated on label (label is
located between terminals) charge battery
for minimum of one hour at 6-10 amps. (See
"BATTERY" in Maintenance
section of this
manual for charging instructions).
*
For batteryand battery cable installation
see "REPLACING
BATTERY"
in the
"Service
and Adjustments"
section
in
this manual.
NOTE: You may now roll your tractor off the
skid. Continue using the instructions
that
follow to remove the tractor from the skid.
Ai_ WARNING:
Before starting,
read, un-
derstand and follow all instructions
in the
Operation section of this manual. Be sure
tractor is in a well-ventilated
area. Be sure
the area in front of tractor is clear of other
people and objects.
Publicidad
