Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Problem
LED "
"
Dust container is too full or filter is soiled.
lights up red.
Switch off the appliance (position "0") and page 29, "Emptying the dust con-
tainer".
In the suction inlet (on the underside of the device) there are 2 sensors which
respond when the suction inlet is heavily soiled.
If this is the case, clean the suction inlet, for example, with a vacuum cleaner.
The cover (over the dust bin, see page 29, "Emptying the dust container")
has not been fitted or has not been fitted correctly.
Make sure that the cover is refitted properly again, for example, after emptying
the dust bin.
The cover may be slightly damaged, preventing a full contact between the cov-
er and the device.
If this is the case, contact customer service department (page 225, "Service
Centres").
Appliance
The slider for setting the sensitivity of the sensors is on a setting for light floors,
switches on but
while the appliance is being used on a dark floor.
only moves
Adjust setting of the slider for the setting of the sensitivity of the sensors,
backwards.
page 27, "Adjusting appliance for floor".
Appliance
Rechargeable battery must be charged.
stops of its own
Switch off the appliance (position "0") and charge rechargeable battery, page
accord.
26, "Recharging the rechargeable battery".
Appliance is
Help the appliance manually by giving it a push.
stuck.
Appliance does
It is possible that dirt is preventing one of the wheels from moving freely.
not move in
Free wheel of dirt. If necessary, carefully use a scissors or tweezers for this.
straight lines
directly after it
is switched on.
One of the
It is possible that dirt is preventing this round brush from moving freely.
round brushes
Clean the round brushes, page 31, "Cleaning the round brushes".
no longer
turns.
Appliance can-
Mains adapter is not plugged in correctly.
not be
Check whether the mains adapter or adapter plug is seated properly in the out-
charged.
let (page 26, "Recharging the rechargeable battery").
Possible cause/Remedy
33
Publicidad
