Publicidad
Idiomas disponibles
Idiomas disponibles
2 Press the on/off button
3 Choose the setting you selected after the skin test (section B, step 9).
4 Press the device firmly onto your skin and hold it in place. The 'READY to
flash' light should light up white.
5 Press the flash button to release a flash on your skin. The flash treats the skin
in that spot.
The device makes a soft popping sound. The flash gives you a warm
sensation.
After each flash, it takes up to 3.5 seconds until the device is ready to flash
again. You can release a flash when the 'READY to flash' light lights up
white.
6 Move to an adjacent spot and press the flash button again. The surface of
the attachment that is in contact with your skin is slightly larger than the
light exit window.
Do not flash the same spot multiple times during a treatment. The surface of
the attachment should overlap the previous spot to make sure you flash the
complete skin area, but treating the same area multiple times does not
increase efficacy.
7 Continue until you have treated the full area. There are two treatment
modes (see 'Two treatment modes: Stamp & Flash and Slide & Flash').
8 Turn off the device when you finished the treatment.
9 Remove hair before every next treatment, as long as hair is still visible.
Note: Do not try the device on difficult or sensitive areas (ankle and bony area).
to turn on the device.
English
17
Publicidad
