UFESA BS NUTRIBOOM Manual De Instrucciones página 16

RECIPE
Food
Carrots
TROUBLESHOOTING
Problem
Motor doesn't start or
attachment doesn't
rotate.
Food is unevenly cho-
pped.
Food is too finely cho-
pped or too watery
Blade is not running
smoothly
You cannot achieve
snow from ice cubes.
Jar is leaking
Unit doesn't turn on
Unit doesn't turn off
Doesn't mix well
Lid/blade assembly
will not properly align
to the jar
CLEANING AND MAINTENANCE
CAUTION: Make Sure that the motor base is unplugged from the power source before in-
serting or removing any attachment and before cleaning.
Wait until the blender has cooled down sufficiently before cleaning it.
CAUTION: DO NOT immerse the motor base into water or any liquid, or place into a di-
shwasher.
Separate/remove all parts from each other.
16
Maximum Amount
320g (carrots) + 480ml (water)
Analysis
For the jars, make sure that the tabs are seated in the slots
and turned clockwise
Either you are chopping too much food at once, or you are not
pulsing properly. Reduce the amount of food in the jar.
The food has been over processed. Use short operating for
best results.
Stop the product and add some liquid, or reduce the ingre-
dients in the cup.
For best result use ice straight from the freezer. Try using
short operating instead of long one.Make sure the jar is com-
pletely dry before adding ice.
Make sure that your lid or blade assembly is properly assem-
bled to the jar. Leaking may occur if it is misaligned when
twisted onto the jar. Turn the lid tightly clockwise.
Make sure the unit is plugged in. Make sure the blade assem-
bly is properly assembled to the jar and that is not misaligned
Unplug the power cord from the electrical outlet and call
customer service for support
Pulse ingredients for best results. Press down on the jar in
short intervals for even blending and chopping. For frozen in-
gredients, pulse in short intervals of 2-5 seconds and repeat.
Set the jar on a level surface. Place the lid or blade assembly
on top of the jar and align the threads so that the lid/blades
sit flat on the jar. Twist clockwise so that the lid/blades even-
ly align to the jar until you have a tight seal.
Approx. time
1 min.