Publicidad
Idiomas disponibles
Idiomas disponibles
EN
5.2.3
TRIM GRASS WITH A TRIMMER HEAD
Trim the grass
1.
Hold the trimmer head above the ground at an
angle. Do not push the cutting line into the grass.
2.
Decrease the speed to decrease the risk of
damage to plants.
3.
Use low-speed mode when cutting grass near
objects.
Clear the grass
1.
Keep the trimmer head above the ground.
2.
Tilt the trimmer head.
3.
Cut with the end of the cutting line around objects
in the work area.
OTHER OBJECTS THAT ARE HIT BY THE
CUTTING LINE, INCREASE THE WEAR ON
THE CUTTING LINE.
4.
Use low-speed mode when cutting and clearing
vegetation. This decreases the wear on the
trimmer head and cutting line.
Cut the grass
1.
Make sure that the cutting line is parallel to the
ground.
2.
Do not push the trimmer head to the ground as
this can cause damage to the product.
3.
Move the product from side to side when you
cut grass. Use high-speed mode for optimal
performance.
English
CAUTION
Sweep the grass
The airflow from the rotating cutting line can be used to
remove cut grass from an area.
1.
Hold the trimmer head and the cutting line parallel
to the ground and above the ground.
2.
Use on high-speed mode.
3.
Move the trimmer head from side to side to
sweep the grass.
5.3
STOP THE PRODUCT
1.
Release the trigger.
2.
Push the battery release button and pull out the
battery to fully stop its operation.
WAIT UNTIL THE MOTOR STOPS BEFORE
YOU REMOVE THE BATTERY.
6
MAINTENANCE
This section describes how to maintain the battery,
battery charger, and product.
10
WARNING
Publicidad
