Descargar Imprimir esta página

GreenWorks STB40003 Manual Del Operador página 12

Cortabordes

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING
CAREFULLY READ AND UNDERSTAND
THE SAFETY CHAPTER AND OPERATION
INSTRUCTIONS BEFORE YOU DO ANY
MAINTENANCE WORK.
Before you do maintenance:
• Stop the product.
• Remove the battery.
• Allow the motor to cool.
• Use correct clothing, protective gloves, and safety
glasses.
6.1
EXAMINE THE BATTERY AND THE
BATTERY CHARGER
Carefully inspect the battery, battery charger, and
connection cord of the battery charger for any signs
of damage, such as cracks or broken parts. Replace if
necessary.
6.2
CLEAN THE PRODUCT, THE BATTERY,
AND THE BATTERY CHARGER
• Clean the product after each use with a moist cloth
and neutral detergent.
• Do not use strong detergents or solvents like "glass
cleaner" to clean the plastic parts or handles.
• Keep the trimmer head free from grass, leaves, or
excessive grease.
• Keep the air vents clean and free of debris to avoid
overheating and damage to the motor.
• Do not spray water on the motor and electrical
components.
• Clean the battery and battery charger with a dry
cloth. Keep the battery guide tracks clean.
• Prior to inserting the battery into the battery charger,
ensure that the terminals on both the battery and the
battery charger are clean.
6.3
REPLACE THE SPOOL
Note: For normal use, head disassembly is
not necessary. However, if circumstances require
disassembly, follow these instructions.
1.
Push the two tabs on the sides of the trimmer
head at the same time.
English
2.
Pull and remove the spool cover assembly.
3.
Remove the remaining cutting line and thoroughly
clean any dirt or debris from all parts.
4.
Remove screws (1), spool (2), slot cover (3), and
location housing (4) from the spool cover (5).
5.
Replace with a new spool.
Note: If any parts of the spool assembly are damaged
or worn, replace the damaged part and reassemble
them as pictured in Step 4.
6.
Place the location housing and slot cover onto the
spool cover, then put the spool onto the slot cover
to the desired position.
7.
Tighten with the screws.
11
EN
5
4
3
2
1

Publicidad

loading