Publicidad
Idiomas disponibles
Idiomas disponibles
33 / EN
5.
Ensure and verify that the green physical ground wire is correctly connected to the
terminal at the charging center.
Pass the cables through the opening on the back part of the heater (see Fig. 4).
6.
7.
Once the above has been completed, you can power the heater to start its operation.
Never omit the electric circuit's ground connection (see Fig. 7). We recommend
connecting the green ground wire to a copper rod (Copperweld).
8.
Grounding the appliance is obligatory, and the cable must be fixed to the ground
connection.
FIG. 7
VII.- HEATER OPERATION
Before using your water heater, make sure you read and follow the instructions in this manual
and all the product labels.
WARNING!
Make sure your heater is completely full of water before turn it on; if you turn on your
heater without water, it will damage the electrical resistance (heating element), and will
void the warranty.
OPERATION AND TEMPERATURE REGULATION
disconnecting the equipment from the electrical power connection.
The light indicator stays On only during the heating phase.
Power relay
-K1
Heating elementgs
-H.E.1
-H.E.2
-H.E.3
PCB indicator
Grounding Diagram
Reed Relay
-RR
-K2
Command switch
-S1
-S2
Wire
Copper rod
(Copperwed), ½"
diameter x 1 m length
Power led
-H1
-H2
-H3
Publicidad
