Publicidad
Idiomas disponibles
Idiomas disponibles
11.-
: headphone output for monitoring, 6.3 mm stereo jack.
12.- USB port for audio file playback.
13.- INPUT: INPUT source selector: AUX (AUX 1+AUX 2), LINE, DIGITAL and player (FM radio, USB and
Bluetooth).
PANEL TRASERO
1
2 3 4
1.- BLUETOOTH ANT: Bluetooth signal antenna.
2.- FM ANT: input for connecting an antenna for FM signal.
3.- DIGITAL - OPTICAL: optical digital audio input, toslink connector.
4.- DIGITAL - COAXIAL: coaxial digital audio input, RCA connector.
5.- MIC: microphone inputs, balanced 6.3 mm jack plug.
6.- MIC - VOX: sensitivity adjustment to give priority to the MIC input over the other inputs. Depending on
this setting, the signal level required at the MIC input to cut the audio from the other sources will be
higher or lower. If the VOX control is set to minimum, no audio will be cut from any output when the MIC
signal is present and the signals will be mixed.
7.- AUX 1/AUX 2: stereo auxiliary inputs for connection of audio devices such as mixers, computers, etc.
2 x RCA connector.
8.- LINE: stereo line input for connection of audio devices such as mixer, computers, etc. 2 x RCA connector.
9.- REC: stereo audio output, 2 x RCA connectors.
10.- OUT 1/OUT 2/OUT 3: audio outputs, 2 x RCA and 2 x XLR connectors. The signal provided will
be stereo (each channel is sent separately) or mono (both channels combined) depending on the
MONO-STEREO selector.
11.- OUT 1 - 3 (MONO-STEREO): selector switch for the configuration of the OUT 1, OUT 2 and OUT 3
outputs operation: mono or stereo.
12.- SUB OUT: subwoofer line output, RCA connector.
13.- Screw for grounding, to be used in case the socket does not have a built-in grounding screw.
14.- GND LIFT: this selector is normally in the
selector switch to the
15.- AC SELECT: power supply voltage selector. If you need to change the voltage you should be aware
that the fuse must be modified as specified on the product.
16.- 115/230 V amplifier power supply input.
1
7
8
9
5
6
1
2
3
4
position to disconnect the earth and ground of the apparatus
7
2 3 4
5
6
10
11
1
2
3
8
5
6
7
position. If the system has ground noises, set the
1
2 3 4
5
6
10
8
9
- 3 -
12 14
15
13
4
5
6
7
10
9
8
9
10
7
12 14
15
11
13
2
3
EN
4
5
USE ONLY WITH A 250 FUSE
16
8
9
11 12 13
1
2
3
4
5
USE ONLY WITH A 250 FUSE
11 12 14
13
16
Publicidad
