Publicidad
Idiomas disponibles
Idiomas disponibles
18. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your product failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Heavy pressure
fluctuations.
Product does not run.
Product has no pressure.
Leaks in the water
system.
Possible cause
Nozzle dirty or clogged.
Product switched off. On/off switch (3)
switched off.
Damaged mains connection cable.
Faulty power supply.
Water supply line pressure drop.
Connections not fitted correctly.
www.scheppach.com
Remedy
Rinse the nozzle with water. If necessary,
clean the nozzle bore with the nozzle
cleaning needle (21).
Switch the product on with the On/Off
switch (3).
Switch the product off and disconnect from
the mains. Check for mains connection
cable for damage.
If necessary, have the mains connection
cable replaced by an authorised specialist.
Check the electrical system for compliance
with the specifications on the type plate.
Check the water supply.
Switch the product off and disconnect from
the mains. Connect the product to the water
lines again.
GB | 29
Publicidad
