Installation; Connecting The Lrf-04; Placing And Connecting The Sensor - CESVA LRF-04 Manual Del Usuario

2. INSTALLATION

The LRF-04 must be installed by a qualified person or firm, according to existing regulations
(ministerial order no. 21712 issued by the Spanish Development Ministry, dated 26/10/1999
for Spain). If not, the guarantee is annulled and
the malfunction of the unit or for any damage directly or indirectly caused to other units
connected to the LRF-04.
The LRF-04 is correctly installed by following these steps:

2.1 Connecting the LRF-04

In order for the LRF-04 to cover the entire sound chain, it must be inserted into the
reproduction chain between the mixing desk and the crossover (see diagram). The back
panel of the LRF-04 features symmetrical (XLR or Cannon connector) and non-symmetrical
(RCA connector) inputs and outputs.
It is vitally important to make sure that the electrical installation to which both the LRF-04 and
the equipment forming the reproduction chain are connected is earthed and complies with
low-tension regulations currently in force.
Mixing desk

2.2 Placing and connecting the sensor

The sensor is placed on the ceiling of the establishment at a point equidistant from the
speakers, using the drills provided. Once the sensor has been placed, it is connected to the
LRF-04 by the connecting cable also provided. Should you need a longer cable than the one
provided, get in touch with any official
connected to the LRF-04, the lid is screwed in place.
Sensor
INPUT
CONNECTOR
2 1
Equalizer
3
1 – GND
2 – + SIGNAL
3 – - SIGNAL
24
will not be responsible for either
Power
OUTPUT
CONNECTOR
amplifiers
1 2
Crossover
3
1 – GND
2 – + SIGNAL
3 – - SIGNAL
LRF-04
distributor. Once the sensor has been
Loudspeaker
Sensor