GRE swim & fun FAQC40 Manual De Instrucciones página 4

EN
INSTALATION
Assemble the filter pump at the location where the pump finally will be.
The filter pump consists of the following parts:
1. 90° connection bracket with o-ring
2. Transparent cover with cap and eliminator pre-assembled
3. Valve big o-ring
4. Clamping ring
5. Filter tank with integrated pump
6. 265g filter balls
Assembly of the filter system (Illustration 1, 2)
Illustration 1
1. Open the clamping ring and remove the transparent cover from the filter tank.
2. Fill the filter tank with the filter balls which are included in the package (approx. 265g).
3. Now place the seal onto the underside of the transparent cover.
4. Lay the transparent cover once again onto the upper side of the filler tank. It is very important to
ensure that all surfaces have been cleaned once again and are free from any dirt before you do this.
5. The transparent cover is connected to the filter tank using the clamping ring. The clamping ring is
screwed together with the clamping ring screw and clamping ring screw nut.
6. Fit the connection bracket on the upper side of the transparent cover.
Illustration 2