Ega Master EGATRONIK 51735 Manual De Instrucciones página 37

CAPACITANCE MEASUREMENT (PICTURE 5)
1) Insert the red test lead into the
2) Turn the function dial to the
capacitance measurement, and connect the test leads with both ends of the measured
capacitance in parallel.
Note:
- If the measured capacitor is short-circuited or the capacitance exceeds the maximum range,
the LCD will display "OL".
- The analog bar pointer is disabled in capacitance measurement mode. When measuring
capacitance >600μF, it may take some time to steady the readings.
- Before measuring, fully discharge all capacitors (especially high-voltage capacitors) to avoid
damage to the meter and user.
- After completing the measurement, disconnect the test leads from the circuit under test.
Picture 5
jack, and black into the COM jack.
position, short press the SELECT button to switch to
37