Sweiss SKYTIG 2033FX Manual De Usuario página 54

Other parameters such as arc force adjustment: press the selection knob : adjust the selection knob
and select the arc force LED, press the selection knob again, the arc force LED is twinkling, it means
the arc force can be adjusted. If the adjustment is completed, press the selection knob and con rm
the parameter; Or the system will con rm the parameter automatically after 3 seconds. Operation
ow as follows:
Step one: 'Welding mode selection switch' selects MMA mode, press the ' selection knob ';
Press the
selection knob
Step two: Adjust the selection knob and select the ARC FORCE LED is on, Press the selection knob
again, the ARC FORCE LED is twinkling, it means the arc force can be adjusted.
Adjust the selection knob
and select the ARC FORCE
LED is on. Press the
selection knob again, the
ARC FORCE LED is
twinkling. It means the arc
force value can be adjusted.
HOT
START
ARC
FORCE
+
SELECTION
SKYTIG 2033
SWEISSWELD.COM
HOT
START
ARC
FORCE
+
SELECTION
SKYTIG 2033
SWEISSWELD.COM
16 SWEISSWELD.COM
TIG ULTRA
pulse
technology
GAS
4T LIFT
MMA
2T LIFT
4T HF
2T HF
Hz
110/220V - 1Ph
TIG ULTRA pulse
technology
GAS
4T LIFT
MMA
2T LIFT
4T HF
2T HF
Hz
110/220V - 1Ph
Welding mode selection
switch select MMA