Publicidad
Idiomas disponibles
Idiomas disponibles
The SA-19/5 is a smoke detector set for discovery of fire in the first stage. If
EN
smoke develops, the SA-19/5 will give a loud beep of at least 85dB (A). We
advice to test the smoke detectors weekly using the test button on the de-
tectors. Save this manual in a safe place or inside of the electricity meter cupboard.
RECOMMENDED INSTALLATION LOCATIONS FOR THE SA-19/5:
•
Install the first smoke detector near the bedroom. Ensure that it is placed so, if
it would detect fire, at least one exit route would still be accessible. We recom-
mend to place one alarm near each potential blockade of your exit route, so
you are alerted before a fire would block off escape.
•
Use multiple smoke detectors to increase safety and ensure an alert before the
escape route is blocked.
•
Install at least one smoke detector on each floor of your house.
•
Install at least one smoke detector in each room where people smoke or where
there is equipment that may potentially cause a fire.
•
Smoke and heat will first move upwards towards the ceiling; after that the
smoke and heat will travel horizontally.
•
Install the detector on the ceiling. Except for rooms smaller than 1m, you
should stay at least 50 cm away from the wall and 60cm from any corner.
Smoke and heat do not gather in such corners, preventing the detector from
alerting you on time.
Required
DO NOT INSTALL IN THE FOLLOWING LOCATIONS:
•
The kitchen; Steam from cooking might give a false alarm.
•
The shower or bathroom; water damp might cause a false alarm and the moist
environment might damage the detector.
•
The garage: The car exhaust might cause a false alarm.
•
In front of a fan or nearby the exhaust of an air conditioner or heater.
•
In a ceiling nook.
•
In rooms where the temperature could reach below 5°C or beyond 45°C.
•
Do not paint or otherwise cover this smoke detector.
INSTALLATION INFORMATION:
Attach the ceiling plate using the included plugs and screws to the ceiling on a
location of choice. Wall mounting is not recommended for smoke detection. Put the
9V block battery in the smoke detector. Then put the detector to the ceiling plate
and, twist clockwise to lock it in place. Perform a first test by holding the test key
for two seconds. Also see the paragraph: "Testing".
Do not use
not in this area
near this space
Pas de cette
salle
61 cm minimum
dead air space
Publicidad
