OPERATION INSTRUCTIONS
1. Flushing and checking for leaks:
Important: After installation is completed, turn on
the hot and cold water supplies. Check for leaks.
Pull the hose assembly out of the spout and remove
the spray head by unscrewing it from the hose in a
counterclockwise direction. Be sure to hold the end
of the hose down into the sink and turn the faucet to
the warm position where it mixes hot and cold water.
Flush the water lines for one minute. This flushes
away any debris that could cause damage to internal
parts. Check for leaks. Do not lose the gasket (1) in
the hose.
Re-tighten any connections if necessary, but do not
overtighten. Reinstall the spray head by hand tightening
it back onto the spray hose in a clockwise direction.
2.
If it is necessary to remove the quick connector (1),
squeeze the tabs (2) on the quick connector and
then pull down to disconnect.
3.
The screen filter in the spray head is dirty. Turn off
the water supply at angle stop and unscrew the spray
head from spray hose. Clean the screen filter in the
spray head under running water.
1
1
2
Squeeze
3
Spray head
7
2
Pull
down
1
1
Screen filter