Publicidad
Idiomas disponibles
Idiomas disponibles
B
Product usage
Assembly/Disassembly
To assemble:
Lift the lever and pull back the latch from the rim of the unit.
Remove the vacuum lid and take out any items stored inside the container. Make sure
you haven't missed any items.
Lie the vacuum on its side and insert the four castors into the base.
Dry vacuum only
Position the dust bag over the suction inlet inside the container.
Slide the HEPA cartridge filter onto the filter core until it is fixed into place.
NOTE: Ensure that the container and all accessories are dry if previously used
for wet vacuuming.
Wet vacuum only
•
Slide the foam filter onto the filter core until it is fixed into place.
•
If you have previously been using the dry vacuum function, make sure you remove the
HEPA filter and dust bag.
Reposition the vacuum lid on top of the container. Clip the top of the latches onto the rim
and press the lever down to fasten it into place.
Use the two screws provided to attach the handle.
Connect the hose, tubes and brush or crevice nozzle by gently pushing the parts together
until they are fixed into place.
•
Floor brush for various types of flooring.
•
Crevice tool for hard-to-reach places and furniture.
Connect the hose (Wet and dry vacuum only)
•
Align the arrow on the hose with the top of the suction inlet. Push the hose into the inlet
to connect it.
•
Turn the hose slightly to the right until it clicks into place.
16
EN
Publicidad
