DJI Mini 2 Fly Guia Del Usuario página 4

EN
Disclaimer and Warning
Please read this entire document and all safe and lawful practices DJI
to read and follow instructions and warnings may result in serious injury to yourself or others, damage to your
DJI product, or damage to other objects in the vicinity. By using this product, you hereby signify that you
have read this disclaimer and warning carefully and that you understand and agree to abide by the terms and
conditions herein. You agree that you are solely responsible for your own conduct while using this product,
and for any consequences thereof. DJI accepts no liability for damage, injury or any legal responsibility
incurred directly or indirectly from the use of this product.
This document and all other collateral documents are subject to change at the sole discretion of DJI.
Introduction
The DJI Mini 2 360° Propeller Guard is used to reduce harm to people or damage to people or objects if they
collide with the spinning propellers. It is recommended to use the propeller guard in windless environments
or during indoor or low-speed flight.
Installation
Make sure all frame arms are unfolded before installing the propeller guard. DO NOT fold the frame arms with
the propeller guard installed.
1. Release the locks on the underside of the propeller guard.
2. Rotate the propellers so that they are positioned directly above the frame arms.
3. Check the mark on the locks of the propeller guard and make sure they are marked FL (Front Left) and
BL (Back Left). Insert the front and rear frame arms of the aircraft's left side through the open side of the
propeller guard and into the corresponding mounting hole. First tilt the front frame arm to help the landing
gear pass through the mounting hole.
4. Make sure the frame arms are properly positioned in the mounting holes and close the locks. A clicking
sound indicates the lock is properly secured.
5. Repeat the steps above to install the propeller guard on the right side. Note that the mark will be FR (Front
Right) and BR (Back Right) for this side.
• DO NOT use the propeller guard in high altitude or windy environments.
• When the propellers are rotating, stay away from the propellers and propeller guard to avoid injury.
• The weight of the aircraft exceeds 250 g after the DJI Mini 2 360° Propeller Guard is installed. Make
sure you understand and comply with the local laws and regulations and, if required, have obtained
corresponding approval and clearance from the related government agencies before flight.
• After installing the propeller guards, hover the aircraft until DJI Fly indicates that the payload has
been detected, and the payload mode is enabled. If the status of the payload mode in DJI Fly does
not match the actual situation, turn it on or off manually in the app.
• After installing the propeller guards, the flight height, flight distance, and maximum flight speed will
be limited. Pay attention to prompts in DJI Fly. To ensure flight safety, the aircraft's recommended
max service ceiling above sea level is 2000 m*. Maintain visual line of sight of your aircraft even
when using the propeller guards.
* If max power load alarm prompts, fly with caution.
Specifications
Weight (one side)
Radius
Installation Circumference
2
23.5 g
71 mm
318 × 267 × 76 mm
TM provided carefully before use. Failure