GE GXWH40L Instrucciones De Instalación página 2

CARTRIDGE SPECIFICATIONS
Performance Data
This housing has been tested according to NSF/ANSI 42
fk)r the reduction ot the substances listed below. The
concentration of the indicated substanc_ s in water
entering th( housing was reduced to a concentration
less than or (qual to the ix rmissibl_ limit for water
leaving the housing, as si)ecifi_ d in NSF/ANSI 42.
FXHTCCartridge
Influent Challenge Reduction Average
Substance Concentration Requirements Reduction
Standard42
Chl o rine 2.0mg/L± 10% >_ 50% 93.1%
TestConditions
Flow Rate:3 gpm(11.4 [pro}
pH:7.5_+1
Inlet Pressure: 6 0 PSi(4.1 bar)
Temperature: 6 8°F_+5°F{19.R°C_+2 5'_C}
OperatinqRequirements
Ressure: 30-100 PSI(2.1-6.9 bar}
Turbidity:5 NTUMax
Tempaature:40°F-IOO°F(4.4°C-37.7°C)
Capacity:5tO00gallons (18r927L} o r 3 months
Testingwasportormedunder standardlaboratoryconditions,actual performancemay var_
Filter CartridgeReplacement
You should (hange your lilter when 111(water l]ow is noti( eablv redu(ed or al h'asl o,'(ry 3 nlonlhs.
[_ Turn offwat_ r to fiher. Rotat{ 1he control handle to th{
BYP'¥";S, , or OFF l)°siti°n (s(_ ValveOperations
S((liOll).
] PFeSS [he Fed l)I-eqS/lFe Fel(ase btll[Oll to l-el('as( pFeSSHI'(.
[_ 1_ llSCl-eW lh( t]her canister alld discard tlsed flllel:
Wash the
filt(r canist(r with mild soap and waten 0o not use balM1
cl(_allel-S 01" hot "_31_'12
[_ Slowly rotal( th{ control handl( to lh( FI[[FER position.
[_ |:'ress
lhe Fed pFess/ll-e rel(ase bllltOll to Felllove
lrapl)ed all:
[_ Af'ter installation, open any downstr(am f)tucet and tlush the
cartridge fi:)r10 minutes, wait one hour, then fhlsh again tot
10 minutes befi:)re using the water. Remote t imer
[_ Insl)(ct the fiher (anister
()-ring.
Make sure it is
lighlly
lubri(ated xdth (lean fbod grade sill(on( greas_ (silk one
grease is a_dlabl( through GE Parts and SexMce:
1.81)0.626.2002, part numl)er WS6OXI(_)05). Be sure the
oqqng is sealed in the groove, h is recomnlended that you
replace th( O_ring iI it is damaged.
[_ Pla(e a new fiher cartridg( inlo the
canisl(l,
making sure it is
('elll( led _111(I ('Oml)lel( Iy seated OIX ll"le [)ollo111 S( _11.
@ Reinslall the filter canister to lhe unil. Use the canisl(r
wr(nch 1o lighI( n lh{ canisten I)O NOT OVERTIG1 ITEN.
canister
ControlHandle
@
OFF
• ShlllsofJx_/l_l:
FiLTER
• Fol flit(led wake: I)ilc(Is water flow
through tilk i_
@
BYPASS
• P(mfits flo_ of_ atel to th( hous_ _dlhoul flowing thlough lh( lilt_l_
(sl Ibis position till filt_ r (hangls el i[ fihcled x_aiel is not desircd.
STEP-BY-STEP INSTALLATION INSTRUCTIONS
Installation Overview
NOTE:Be sure to allow a minimum space
of 1½"2" under the filter for removing
the sump to change the cartridge.
Mounting
ket
Fitting
Ferrule
Hex nut
Hex nut
shut-off valve
Typical instaflation
Recommended
shut-0ff v alve
2 j