Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Horizontal Saw Bench and Diagonal Cuts
The saw bench can be positioned into a 45° diagonal position or be left in the horizontal position.
You can read off the approximate slope angle by using the angle scale located under the work bench. For
more exact adjustment, use scrap wood for some saw tests; adjust the bench if necessary.
A scroll saw is fundamentally a "curve cutting tool" but which can also carry out straight and angled edge
cuts. Familiarise yourself with the following important points prior to commissioning the saw.
• The saw does not automatically cut wood. You must feed the wood against the saw blade manually.
• The cutting process occurs only while the blade is moving downwards.
• Feed the wood slowly against the saw blade as the saw blade teeth are small and cut only while moving
downwards.
• All persons carrying out work with the saw require training. The saw blade may break easily during this
training time while the operator is still unfamiliar with the saw.
• The saw is best suited for sheets of wood less than 2.5 cm thick.
• Feed the wood especially slowly against the blade and avoid abrupt curves to prevent the saw blade
from breaking, if you wish to cut wood sheets thicker than 2.5 cm.
Publicidad
