Publicidad
Idiomas disponibles
Idiomas disponibles
Lubrication
Lubricate the saw arm bearings every 50 hours. Proceed as above figure shown. Turn the saw to the side.
Apply a generous amount of SAE 20 oil to the shaft end and bronze bearings. Let the lubricant oil work in
overnight. Repeat the procedure the next day on the other side of the saw.
Carbon Brushes Inspection
In case of excessive sparking, have the carbon brushes checked only by a qualified electrician.
Danger! The carbon brushes should not be replaced by anyone but a qualified electrician.
Transport
1. Be sure turn off the power and pull out the plug after use.
2. Pull down the transparent blade guard to prevent hand cutting during transportation.
3. Disconnect the vacuum cleaner and the other connecting devices, and remove the connection bolts
between the machine and the worktable.
4. Hold the upper end of the U-shaped arm with one hand while moving; If the saw-blade adapter &
allen wrench (Optional Feature A) is on the top of the U-shaped arm, you can move it with both
hands.
5. Raw materials or precision-cut semi-finished products are recommended to be removed from the
worktable before moving, which may damage the saw blade and its fixing device.
Storage
Store the equipment and accessories in a dark and dry place at above freezing temperature. The ideal
storage temperature is between 5 and 30°C. Store the electric tool in its original packaging. Cover the
electric tool in order to protect it from dust and moisture.
EN
1 – Oil Seal
Publicidad
