Publicidad
Idiomas disponibles
Idiomas disponibles
EN
• Saw blade teeth becomes blunt over time, saw blades must be replaced. The saw blades are sufficient
for 1/2 to 2 operating time depending upon the type of wood.
• Try and make sure that the saw blade follows the grain of the wood in order to obtain a clean cut.
• The saw speed must be reduced to minimum when cutting precious and non-ferrous metals.
Inside Cuts
Warning: Switch off the saw and remove the mains supply plug before doing inside cuts in order
to avoid injuries caused by unintentional activation of the saw.
This saw is suited also to inside cuts cut not starting at the edge of the work piece. Proceed as follows:
• Drill a 6 mm hole in the work piece.
• Loosen the clamping screw (blade tensioner) and release the tension in the blade.
• Place the bore hole over the saw blade slot in the work bench.
• Install the saw blade through the hole in the work piece and through the work blade slot, and fasten the
blade to the holders.
• When you have completed the inside cut, remove the saw blade and then remove the work piece from
the bench.
Continuous Operation
It is possible to switch the saw on by pressing the green "I" button for continuous operation. In order to
switch the saw off, it is necessary to press the red "0" button. With the continuously variable electronic
speed control, the cutting speed can be increased by turning to the right or reduced by turning to the left.
1 – Red "0" button
2 – Green "I" button
3 – Speed Switch
Publicidad
