Descargar Imprimir esta página

Master STP 135-S exact Instrucciones Para El Manejo página 12

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 30
0702645X - GB Seite 12 Samstag, 15. Mai 2004 8:34 08
GB
Working safely with this machine
is possible only when the operat-
ing and safety information are
read completely and the instruc-
tions contained therein are strictly
followed. In addition, the general
safety instructions in the enclosed
booklet must be followed.
Wear safety goggles.
If the mains cable is damaged or cut
through while working, do not
touch the cable but immediately pull
the mains plug. Never use the
machine with a damaged cable.
When working, never guide a hand or fingers
in front of the saw blade.
Connect machines that are used in the open via
a residual current device (RCD) with an actuat-
ing current of 30 mA maximum. Do not operate
the machine in rain or moisture.
Always direct the cable to the rear away from
the machine.
Do not work with materials containing asbes-
tos.
12
For Your Safety
Apply the machine to the workpiece only when
switched on.
The cutting path must be free of obstacles both
above and below.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
securely than by hand.
When sawing, the complete surface of the base
plate 7 should securely rest on the material. For
the working of smaller or thin workpieces, use
a stable foundation or a saw table (accessory).
When the cut is completed, switch off the
machine and then pull the saw blade out of the
cut only after it has come to a standstill (danger
of kick-back).
Always switch the machine off and wait until it
has come to a standstill before placing it down.
Do not brake the saw blade to a stop by apply-
ing side pressure after switching off.
Use only sharp, flawless saw blades. Change
cracked, bent or dull saw blades immediately.
Never allow children to use the machine.
Do not drill into housing or attach rivets in order
to mark the machine. The double insulation is
then no longer ensured. Use stickers.
Use only original Würth parts and accesso-
ries.
For further notes on safety refer to the enclosed sheet

Publicidad

loading

Este manual también es adecuado para:

Stp 135-b exact