Master STP 135-S exact Instrucciones Para El Manejo página 14

0702645X - GB Seite 14 Samstag, 15. Mai 2004 8:34 08
For switching off the Exact Cut function, eject the saw
blade and reinsert it again, as required. Caution!
The saw blade can be hot. Wear protective gloves.
Ejecting the Saw Blade (see figure
To eject the saw blade, fully press the clamping
lever 18 towards the front; this releases and ejects
the saw blade.
Initial Operation
Always use the correct supply voltage: The power
supply voltage must match the information quoted
on the tool identification plate.
Switching On and Off
STP 135-B exact
To start the machine, press the On /Off switch 3 and
keep it depressed.
To lock on , push the lock-on button 2 to the left or
right while the On/Off switch 3 is pressed.
To switch off the machine, release the On /Off
switch 3 or push and release it then.
STP 135-S exact
To start the machine, press the On /Off switch 3 for-
ward.
To switch the machine off , press the On/Off
switch 3 to the rear.
Electronic Soft Start
The electronic soft start feature increases the service
life of the motor and the mechanical transmission.
After brief soft starting, the machine reaches the
preselected stroke speed.
Constant Electronic Control
The constant electronic control keeps the stroke
speed at no-load and under load almost constant;
this ensures uniform operation feed and an even cut-
ting pattern.
Stepless Stroke-speed Control
( )
STP 135-B exact
Lightly pressing the On /Off switch 3 results in low
stroke speed. Applying more pressure increases the
stroke speed.
14
Stroke Rate Preselection
The required stroke rate can be preselected (also
during operation) using the thumbwheel 4 .
)
1 – 2 = low stroke rate
B
3 – 4 = medium stroke rate
5 – 6 = high stroke rate
The required stroke rate is dependent on the mate-
rial and the working conditions and can be deter-
mined by a practical trial.
After working for longer periods at low stroke rate
allow the machine to cool down by running it at
maximum stroke rate and no-load for approx.
3 minutes.
Contact Protector
The contact protector 16 attached to the housing
prevents unintentional contact with the saw blade
while working and should not be removed.
Sawdust Blower Device
The sawdust blower device leads an air jet to the
saw blade. The air jet keeps sawdust from covering
the cutting line during operation.
The air flow can be switched on or off with the switch
for the sawdust blowing device 9:
Pendulum Action Setting
Step 0:
Step I:
Step II:
Step III:
Blower effect switched on:
For working with wood, plastic and
similar materials that produce large
amounts of sawdust.
Blower effect switched off:
For working with metals and with use
of coolant/lubricant as well as when
using dust/chip extraction.
The pendulum action can be adjusted
in four steps with the adjustment
lever 10. Switching is possible with
the machine running:
No pendulum action
Small pendulum action
Medium pendulum action
Large pendulum action