Uline H-11225 Manual De Instrucciones página 2

1. Adhere four rubber pads on corresponding holes of
each support plate. (See Figure 1)
Figure 1
2. Place support beam on a smooth, non-marring
surface with center brackets facing up. Align left
and right support plates with ends of support beams
and attach using four M6 x 12 mm socket cap
screws with flat head (E) with 4 x 4 mm Allen wrench.
(See Figure 2)
Figure 2
3. Flip assembly so that center brackets on support
beam are now facing down. One of the lifting
columns comes with the short end of the
transmission rod already inserted into it. This is the
lifting column which the crank handle will attach
to. Determine which side of the table you want
the crank handle on and place this specific lifting
column plate onto threaded holes in support beam.
Place other lifting column onto opposite side of
support beam. Attach using eight M6 x 12 mm
socket cap screws (B) and 4 x 4 mm Allen wrench.
(See Figure 3)
PAGE 2 OF 18
ASSEMBLY
Pads
Pre-Installed
NOTE: When installing, keep the height of the
left and right lifting columns the same.
Figure 3
4. Place feet onto lifting columns, aligning holes in
feet to threaded inserts on bottom of lifting columns.
Attach using eight M6 x 30 mm socket cap screws (C)
with 4 x 4 mm Allen wrench. (See Figure 4)
Figure 4
B
Front
Back
C
1223 IH-11225