Uline H-11225 Manual De Instrucciones página 5

11. Flip table upright. Place M8 x 12 mm socket cap
screws (A) into side mounting plates on left lifting
column when facing the front of table.
(See Figure 14)
IMPORTANT! Do not fully tighten. Leave large
portion of thread to allow for installation of
stringer.
Figure 14
12. Align stringer between lifting columns, lining up with
side mounting plates. Access hole in stringer should
face the back side of the workbench. Loosen Allen
head bolts on bottom of stringer to expand to width
of lifting columns. (See Figure 15)
Figure 15
13. Place keyhole slots on end of stringer onto previously
installed M8 x 12 mm socket cap screw (A) threads.
Push stringer down so bolts are in smaller holes on
slots. (See Figure 16)
Figure 16
PAGE 5 OF 18
ASSEMBLY CONTINUED
A
Back
View
14. Align opposite end of stringer with side mounting
plate. Insert two M8 x 12 mm socket cap screws (A)
through stringer and into side mounting plate. Tighten
all M8 x 12 mm socket cap screws (A) to secure.
(See Figures 17-18)
Figure 17
15. Place stringer cover over holes on stringer. Tighten
Allen head bolts on bottom of stringer to secure.
(See Figures 19-20)
Figure 19
A
Figure 18
Figure 20
1223 IH-11225