Costway NP11460 Instrucciones De Montaje página 5

Step 1: Pull out the canopy frame:
A. Place the canopy frame in the center of the area that needs
shade.
B. With your partner on the other side of the frame, grab both
outer legs and lift the frame slightly off the ground. Then pull the
frame back so that it opens to 3/4 of its full opening size. Finally,
place the frame back on the ground.
NOTE: Do not open the violently; improper force may
cause damage to the brackets or connectors.
Step 2: Attaching the pop-up canopy top:
A. Unfold the pop-up canopy top and place it on top of the pop-up
canopy frame.
B. Secure the pop-up canopy top to the corners of the canopy
frame using the hook and loop fasteners.
08
If the cloth does not seem to fit, you need to adjust the
degree of opening of the tent frame.
Step 3: Locking the frame:
A. At this point, stand with a partner on the opposite side of the
frame and grab the outside bar. Pull it back until the shelter is fully
open.
B. Then push upward with one hand while holding the top of the
leg with the other hand to engage the slider at each corner.
Repeat this procedure on
the other legs.
C. Lift all the corners
upward until they click,
and the snap goes into
the positioning hole.
09