Publicidad
Idiomas disponibles
Idiomas disponibles
5. INSTALLATION
ATTENTION!
This unit is designed to be installed and used on a wall. Do not connect the power cable
until the installation is complete! Get a second person to help you with the installation.
Keep this information in mind when mounting the unit.
5.1 Delivery package
After unpacking, check that the delivery is complete and that all parts are free of possible
See image
transport damage.
1. - cooker hood
2. - pipe mask (2 pcs.)
3. - oil collector
5.2 Unit dimensions (mm)
See images
2a
2b
5.3 Safety distances
Observe the safety distances from the unit (calculated in mm).
5.4 Installation steps
1..Drill 3 holes (Φ8mm to adapt your wall plugs) to place the bracket. Screw and tighten
the bracket to the wall with the screws 3 Screws (ST4x30mm) and 3 wall plugs (not
supplied).. See image
2. Place the range hood and hook it by using the two notches on the wall bracket. See
image
4b
3. Slide the upper shaft part into the lower one. Attach the shaft bracket to the lower/ outer
shaft part. See image
4. Place the shaft on the hood body and mark the mounting holes on the wall. Remove the
shaft and drill the holes at the marked points. For exhaust air operation of the hood, attach
the exhaust hose (not included) to the air outlet of the hood body. See image
5. Re-attach the exhaust shaft onto the hood body, passing the exhaust hose through
the shaft and connecting it to the exhaust opening if needed. Fix the lower shaft bracket to
the wall with 2 plugs and screws (4 x 30 mm). See image
6. Pull out the upper / inner shaft part to the desired height upwards, mark the
mounting holes for the upper shaft bracket on the wall and pre-drill the marked points. Fasten
the upper shaft bracket with 2 dowels and 2x ST4 x 30mm screws on the wall
at the drilled points. Fasten the upper / inner shaft part to the bracket with 2 x ST4 x 8mm
screws. See image
7. Make sure that the lower end of the outer shaft part rests on the hood body. It is not
necessary to screw the shaft to the hood body.
5.5 Fitting the active carbon filter (Code TCF 1) and oil collector
In the air recirculation mode, carbon filters capture substances with unpleasant odors. By
regularly replacing the carbon filters, a high degree of elimination of unpleasant odors is
ensured. Carbon odor filters cannot be cleaned or regenerated.
1.
Active carbon filters Turbionaire TCF1 are optional (not included in the package) and are
used for kitchen hoods used in recirculation. The filter kit consists of two pieces that are
mounted after turn off the unit, removing the grease filters and the oil collector, inside the
hood, on the sides of the engine by rotation. See image
2.
After installing the active carbon filters Turbionaire TCF 1, install the grease filters and the
oil collector. For how to install the oil collector, see the image
1
4. - shaft bracket
5. - cooker hood bracket
6. - adapter 150 - 120 mm
7. - non-return valve
2c
2d
4a
4c
4f
EN
See image
4e
5a
16
3
4d
5b
Publicidad
