Publicidad
Idiomas disponibles
Idiomas disponibles
5.6 Connection to the air recirculation system
1.
Mount the carbon filters for odors (code: TCF1) - optional accessory
2.
Attach the air exhaust tube to the hood connection (optional accessory)
5.7 Making the electrical connection
Insert the plug into the socket with protective contact.
5.8 Unit Disassembly
WARNING - Risk of injury!
Components inside the unit may have sharp edges.
Wear protective gloves.
1.
Disconnect the unit from the mains power supply.
2.
Undo the air exhaust tube.
3.
If necessary, open the filter cover (for models with this cover)
4.
Remove the grease filter. To prevent damage, do not bend the grease filter.
5.
Disconnect the control panel harness and the lighting system harness.
6.
Slowly lower the unit.
6. USE - FUNCTIONS
ATTENTION! LED lamps must not be covered with thermal insulation or other materials.
NOTE! Only turn on the LED lights while the hood is running. Do not turn on the lights to
illuminate the room. Do not touch the LED lamps within 30 minutes after use units.
6.1 Control panel
Via the operating elements you set all the functions of your unit and receive information
about the operating status.
Unit stop button.
Button for selecting minimum speed.
Button for selecting average speed.
Button for selecting maximum speed.
LED light On/Off button
6.2 Starting the unit
Press
The unit starts in ventilation stage 1.
6.3 Adjusting the speeds
Press the desired speed level
Note: The activated speed level will be indicated by means of the LED associated with
the button.
6.4 Stopping the Unit
Press
EN
17
Publicidad
