Panasonic AW-PH360L Manual De Instrucciones página 23

Installation
w Installing the pan-tilt head
When installing the pan-tilt head, check the "Pan-tilt head mounting conditions" (page 20),
and be sure to follow the instructions below.
In order to prevent accidents caused by the pan-tilt head dropping out or falling off, be
absolutely sure to install a drop prevention underneath support plate separately from the
pan-tilt head.
Do not install the unit on its side because it will not be able to operate or perform as
originally designed.
p The installation surface must have a withdrawal strength of at least 340 N (35 kgf) for
each anchor used.
p After fashioning the anchors or hangers, install the pan-tilt head, and take measures to
prevent it from dropping.
p After the pan-tilt head has been installed, mount the camera onto the pan-tilt head.
p Embed the anchors to the depth recommended by the manufacturer of the anchors.
p Use M6 bolts or nuts for the pan-tilt head mounting holes (4 locations) to install the
pan-tilt head.
p Use the M8 bolt or nut for the underneath support plate hole (1 location) to install the
underneath support plate.
p When mounting onto anchors with external threads, check that the anchor bolts
protrude at least 7 mm from the nuts used to mount the pan-tilt head and underneath
support plate. (Fig. 1)
p When mounting onto anchors with internal threads, check that the bolts engage with
the female anchors to a depth at least two times the bolt diameter. (Fig. 2)
p Be absolutely sure to use the flat washers and spring washers for the hexagon head
bolts and nuts.
Recommended tightening torque:
For tightening, use a torque wrench with which the torque can be specified.
p Avoid installation on plaster board or wooden surfaces since these surfaces are not
strong enough.
p Install the pan-tilt head so as to ensure that none of the components mounted on the
pan-tilt head or cables will come into contact with any objects in the vicinity when the
pan-tilt head rotates.
Contact between the unit and an object in the vicinity may trigger the safe mode
function.
For further details, refer to "Concerning the safe modes" (page 33).
(Be sure to ask your dealer to install the unit.)
Bolts
Hexagon head bolts (M6)
Hexagon head bolt (M8)
- 22 (E) -
Installation work
Clamping torque
5.0 N m (50 kgf cm)
• •
12.0 N m (120 kgf cm)
• •