Panasonic AW-PH360L Manual De Instrucciones página 40

Connections
 VIDEO OUT connector
This is for camera video signal output.
Connect this to a monitor, etc.
Use a coaxial cable (BNC) for the
connecting cable.
 CAMERA CONTROL IN connector
This is for camera control signal input.
Connect this to the CAMERA
CONTROL OUT connector on the
controllers (AW-RP501/AW-RP505), or
multiport hub (AW-HB505).
Use a coaxial cable (BNC) for the
connecting cable.
 SDI OUT connector
This is for SDI signal output.
Connect this to a monitor, etc.
Use a coaxial cable (BNC) for the
connecting cable.
Cable used when HD-SDI signals are output:
5C-FB, up to 80 m
Cable used when SD-SDI signals are output:
5C-2V, up to 150 m
 CONTROL IN RS-232C connector
This is for RS-232C control signal input
from the personal computer.
Use the AW-CA28T9 cable (option) for
the connecting cable.
The AW-CA28T9 is 10 m long.
When extending the length, please use
an RS-422, converting back to the
RS-232C at the pan-tilt head.
<Notes>
p When connecting with the controllers
(AW-RP605A, AW-RP555, AW-RP655
or AW-RP400) at the same time,
connect with controller's REMOTE
terminal.
p When the controller (AW-RP301,
AW-RP305, AW-RP501 or AW-RP505)
and a personal computer are to be
used at the same time, the camera
is controlled by the controller if
the controller is connected to the
 CAMERA CONTROL IN connector.
If this connector is not connected, it is
controlled by the personal computer.
p Information such as pan-tilt head
position, lens zoom, focus, iris, etc.
can be accessed by the personal
computer, however, white balance set
by the controller cannot be accessed.
- 39 (E) -