Publicidad
Idiomas disponibles
Idiomas disponibles
EN
SET-UP
debris. Do not install the product over concrete or any hard surface.
from any structure or
obstruction such as a fence, garage, and house, overhanging branches, laundry
lines or electrical wires.
moisture. lf water contacts the blower (air pump), unplug the blower (air
pump) power cord. Do not operate until the blower is completely dry.
product is stretched well from top to end. Be sure to place the product as close to
the power source as possible.
Ensure
the inflation tube is securely attached and in good condition. The inflation tube
should be straight and untwisted. Reposition the blower (air pump) if necessary.)
instruction. Otherwise, overleap this point. Spread out the product, place and
fasten the empty water bags on the two sides of the product. Open the stopple
and fill water in the water bags until 80% full (about 22 KG/49 LBS), push and
close the stopple. Make sure water bags are firmly attached to the product and no
water leakage before the product is fully inflated, and never allow children to play
on the slide without installing a water bag. (Refer to picture A)
hammer for proper placement. Make sure the blower (air pump) power switch is in
the OFF position. Ensure the power connections are safely sited and tripping
hazard is minimized.
use. Plug the blower (air pump) into an approved ground outlet.
04
Publicidad
